Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
show interface radio tl-spec
141
Cisco IOS Release 12.1(5)XM
show interface radio tl-spec
To display the details of the currently-configured timeline specifications, use the show interface radio
tl-spec privileged EXEC command.
show interface radio slot/port tl-spec [statsParams {MAC-address | chan-id}]
Syntax Description
Defaults No default behavior or values.
Command Modes Privileged EXEC
Command History
Examples The following example shows how to display the timeline specification for the radio card in slot 6,
port 0:
Router# show int radio 6/0 tl-spec
slot/port The slot and port numbers of the radio card.
statsParams {sinr-ant1 | sinr-ant2 | sinr-total | timingOffset | rf-rx-power-ant1 |
rf-rx-power-ant2 | chan-delay-spread-ant1 | chan-delay-spread-ant2 |
power-amb}
The data for the radio attribute is collected as a histogram.
sinr-ant1 Signal-to-interference plus noise ratio for antenna 1.
sinr-ant2 Signal-to-interference plus noise ratio for antenna 2.
sinr-total Signal-to-interference plus noise ratio for antennas 1 and 2.
timingOffset Represents the timing delay variations detected in the radio link.
rf-rx-power-ant1 Represents the receive power at the main RF headend (antenna gain is not
included).
rf-rx-power-ant2 Represents the receive power at the diversity RF headend (antenna gain is
not included).
chan-delay-spread-ant1 The offset for channel delay spread on antenna 1.
chan-delay-spread-ant2 The offset for channel delay spread on antenna 2.
power-amb Represents the noise floor of the ambient environment, in decibels.
MAC-address Specifies the MAC address for a particular subscriber unit.
chan-id Specifies an upstream channel ID.
Release Modification
12.1(3)XQ1 This command was introduced.