Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
pppoe enable
28
Cisco IOS Release 12.1(5)XM
pppoe enable
To enable Point-to-Point Protocol over Ethernet (PPPoE) termination on the radio interface, use the
pppoe enable interface configuration command. To disable, use the no form of this command.
pppoe enable
no pppoe enable
Syntax Description This command has no arguments or keywords.
Defaults By default PPPoE is disabled.
Command Modes Interface configuration
Command History
Usage Guidelines The pppoe enable command and the pppoe-forwarding command cannot be configured at the same
time. You can configure only one or the other at any given time.
Examples The following example shows how to enable PPPoE on the radio interface:
Router(config-if)# pppoe enable
Related Commands
Release Modification
12.1(3)XQ1 This command was introduced on the fixed wireless multipoint product.
Command Description
pppoe-forwarding Enables PPPoE forwarding on the router.
show interface Displays information about whether or not PPPoE termination or PPPoE
forwarding is enabled.