Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
Monitoring and Maintaining Multipoint Wireless Configurations
12
Cisco IOS Release 12.1(5)XM
Verifying the Wireless Modem Card Configuration
Step 1 Enter the show running-configuration command in privileged EXEC mode to display the
configuration currently in effect on the Cisco uBR7200 series.
Step 2 Enter the show startup-configuration command in privileged EXEC mode to display the system
startup configuration.
For a complete list of commands to verify the installation and configuration of your fixed wireless
multipoint system, see the “Verification Commands”section.
Monitoring and Maintaining Multipoint Wireless
Configurations
This section describes the clear and show commands that are used to monitor and maintain the
multipoint fixed wireless system. For a complete list of commands to monitor and maintain your fixed
wireless multipoint system, see “Monitoring Commands” under the command reference section. For the
syntax and description of a command, refer to the “Command Reference” section of this document.
Step 4
Router(config-if)# end
Exits the interface configuration mode and get to
the EXEC mode.
Step 5
Router# show interface radio
slot/port
alc
Displays the ALC setting that you specified.
Command Purpose
Command Purpose
Router# clear radio flap-list
Clears the current radio flap-list entries for a
specific subscriber unit or for all subscriber units.
Router# clear radio link-metrics
Clears the link metrics settings.
Router# clear radio subscriber counters
Clears the counters for a radio modem or all radio
modems in the Station Maintenance List.
Router# clear radio subscriber reset
Resets the radio modem or all radio modems on the
network.
Router# show controllers radio downstream
Displays downstream port information for a
wireless modem card.
Router# show controllers radio if
Displays the IF hardware information for the
specified radio interface.
Router# show controllers radio rf
Displays the RF hardware information for the
specified radio interface.
Router# show controllers radio upstream
Displays upstream port information for a wireless
modem card.
Router# show interfaces radio metrics
Displays the parameters measured during the
operation of the radio link.
Router# show interface radio accounting
Displays radio accounting information for a
wireless modem card.