Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
show radio subscriber
160
Cisco IOS Release 12.1(5)XM
Modem State The status of the modem when it was last polled. Possible states
are:
init(o)—Option file transfer was started
init(t)—Time-of-day (TOD) exchange was started
init(r1)—Modem sent initial ranging
init(r2)—Modem is ranging
init(rc)—Ranging is complete
init(d)—Dynamic Host Configuration Protocol (DHCP) request
was received
init(i)—DHCP reply was received; IP address assigned
online—Modem registered; enabled for data
online(d)—Modem registered but network access for the cable
modem is disabled
online(pk)—Modem registered; baseline privacy interface (BPI)
enabled, and key encryption key (KEK) is assigned
online(pt)—Modem registered; BPI enabled, and traffic
encryption key (TEK) is assigned
reject(m)—Modem did attempt to register; registration was
refused due to bad mic
reject(c)—Modem did attempt to register; registration was
refused due to bad COS
reject(pk)—KEK modem key assignment is rejected
reject(pt)—TEK modem key assignment is rejected
offline—Modem is considered to be offline.
Offline Time—Time the modem went offline. The format is same
as other show radio subscriber commands (month, day, time, and
year info).
Offline Time For offline modems, the time the modem went offline.
Previous State For offline modems, the status prior to going offline. See Modem
State for definitions.
Rx Power This field is not currently used.
SM Exhaust Count The number of times the headend declared that modem to be
offline. The modem could be marked offline due to various
reasons (modem went dead, modem has not been active for a
while, and so on).
Access group The access group number.
Table 4 show radio subscriber Field Descriptions (continued)
Field Description