Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio rf-meas-interval ambient
88
Cisco IOS Release 12.1(5)XM
radio rf-meas-interval ambient
To set the measurement interval of the ambient noise for performing noise floor statistics (NFS)
functions, use the radio rf-meas-interval ambient interface configuration command. The NFS
functions allow the user to determine the noise floor of the radio link and make adjustments to the
system, (for example, adjust the target receive-power level of the upstream port). To set the interval to
the default value, use the no form of this command.
radio rf-meas-interval ambient aint-seconds
no radio rf-meas-interval ambient
Syntax Description
Defaults 300 seconds.
Command Modes Interface configuration
Command History
Examples The following example shows how to set the ambient noise measurement interval to 400 seconds:
Router(config-if)# radio rf-meas-interval ambient 400
Related Commands
aint-seconds Specifies the ambient measurement interval in seconds. Valid values are 1
3600 seconds. The default value is 300 seconds.
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
radio rf-meas-interval
calibration
Sets the measurement interval of a calibrated noise source.
show interface
slot/dsport
rf-meas-interval
Displays the intervals of the ambient noise and the calibration noise
measurements of the radio card for the specified slot and downstream port
numbers.