Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio interface radio rf-update duplexer
63
Cisco IOS Release 12.1(5)XM
Command History
Usage Guidelines You must specify the antenna, either 1 or 2, for which you want to update the duplexer settings. If no
parameter is specified after 1 or 2, the existing duplexer settings will be removed. Although the valid
frequency ranges for the high-band and low-band are the same, the frequency range for hi-band start
and end values must be set higher than the frequency range for low-band start and end values.
Overlapping is not allowed between the bands.
Note This command can be entered only when the radio link is down (shut), and takes effect
when the link becomes active again (no shut).
Examples The following example shows how to set the radio frequency for the duplexer:
Router# radio int radio 6/0 rf-update duplexer 1 08232000 2550 2600 2650 2700 10 tx-lo
Related Commands
Release Modification
12.1(3)XQ1 This command was introduced.
Command Description
show controllers radio
slot/port rf
Displays the current settings for the duplexer.