Filter
Top Products
Multipoint Wireless Support for the Cisco uBR7200 Series Universal Broadband Router
radio upstream shutdown
109
Cisco IOS Release 12.1(5)XM
radio upstream shutdown
To activate the radio frequency carrier on the upstream ports, use the radio upstream shutdown
command. Each upstream port must be activated to enable upstream data from the subscriber units to
the Cisco uBR7200 series. To enable upstream data traffic, use the no form of this command.
radio upstream portnum shutdown
no radio upstream portnum shutdown
Syntax Description
Defaults The upstream data traffic is disabled.
Command Modes Interface configuration
Command History
Examples The following example shows how to activate upstream port 2 to enable upstream data flow from the
subscriber unit to the headend:
Router(config-if)# radio upstream 2 shutdown
portnum Specifies the upstream port number. Valid values are o to 3.
Release Modification
12.1(3)XQ1 This command was introduced.