Filter
Top Products
Configuration Extensions
102
372 SPU 780 01EMAN May 2002
Configuration Extensions
Overview Configuration extensions can be edited while the project is either online or offline.
Online changes can only be made to a stopped controller. The configuration
extension information is stored within the project and can be loaded at any time.
Available configuration extensions listed in the Active Extensions panl:
Configuration Extension Description
Data Protect Prevents specific blocks of 0xxxx and 4xxxx references from
being modified by general Modbus data write commands.
Peer Cop Allows you to configure data blocks to be transferred between
controllers on a Modbus Plus network.
S980 Addresses Specifies the S980 station address.
Quantum Hot Standby Allows additional configuration of the Quantum Hot Standby
setup.
Profibus Configures a Quantum controller for Profibus communications.
TCP/IP Configures controllers to connect to a TCP/IP network through a
communication card.
SY/MAX Configures a Quantum controller for communication with SY/
MAX drops.
I/O Scanner Allows you to configure data blocks to be transferred between
controllers on a TCP/IP network.
Compact Phase II This extension is only available for Phase II Compact PLC’s
VME Bus Configures a VME controller for communications with a VME
network.
Note: Before setting config extensions, you must set the Configuration Extension
Size parameter in the controller configuration editor. For more information see,
Configuring a Controller, General Tab Parameters, p. 77.