Filter
Top Products
Working with Projects
40
372 SPU 780 01EMAN May 2002
Setting the
Default Address
Data Values
You can toggle discretes or transfer values to arrays of registers during emulation
when setting states or register contents on a state or value.
Step Action
1 In the Emulation Properties tab, enter an address or a range or addresses in the
format (axxxx-axxxx) in the Address Range field.
2 If you have entered an analog address range, enter a value in the Data Value
field. If you have entered a discrete address range, select a data value (Off, On,
Enables, Disabled Off, Disabled On) from the Data Value drop-down list.
3 If you have entered an analog address range, select a radix for the address
range from the Radix drop-down list.
Note: Floating point only works with two registers. All others can be set to work
on ranges of addresses.
4 Click OK to save the changes and return to ProWORX 32.
5 To load the default address values while in Emulation mode, select Emulation
→
Load Default Address Values from the logic editor right-click menu.