Filter
Top Products
AWG710 Service Manual
6-1
Maintenance
This section contains the information needed to perform periodic and corrective
maintenance on the AWG710 Arbitrary Waveform Generator.
The following subsections are included:
H Related Maintenance Procedures. Provides information relating to various
sections discussing maintenance.
H Preparation. Introduction plus general information on preventing damage to
internal modules when doing maintenance.
H Inspection and Cleaning. Information and procedures for inspecting the
waveform generator and cleaning the external and internal modules.
H Removal and Installation Procedures. Procedures for the removal of
defective modules and replacement of new or repaired modules.
H Troubleshooting. Information for isolating failed modules. Included are
instructions for operating the waveform generator internal diagnostic
routines and troubleshooting trees. Most of the trees make use of these
internal diagnostic routines to speed fault isolation to a module.
Related Maintenance Procedures
The following subsections contain information and procedures related to
maintenance.
H Operating Information provides useful troubleshooting instructions when
operating the waveform generator. It also details the service strategy and lists
options for obtaining maintenance service and replacing failed modules.
H Theory of Operation contains a circuit description at the module, or block,
level.
H Performance Verification provides procedures that may be useful in isolating
modules problems by testing the waveform generator performance.
H Adjustment Procedures addresses after repair adjustment and the interval
between periodic adjustments. It contains a procedure for adjusting the
internal circuits of the waveform generator.
H Diagrams contains a block diagram using individual modules as blocks and
an interconnection diagram showing connections between the modules.
H Replaceable Mechanical Parts lists all field replaceable modules by part
number.