Filter
Top Products
Removal and Installation Procedures
AWG710 Service Manual
6-33
You will need a screwdriver with a size #2
Phillips tip (Table 6–4, Items 1
and 3).
1. Locate the modules to be removed in Figure 6–3, on page 6–13.
2. Do the Trim Ring, Menu Button and A20 Front Panel Assembly procedures
immediately preceding this procedure.
3. Orient the waveform generator so the bottom is on the work surface and the
front panel is facing you (see Figure 6–16).
4. Unplug the LCD and Back Light connectors J225 and J245 on the A10
Connector board.
5. Unplug the LCD connector on the right side of the LCD display by pushing
toward the rear panel.
6. Remove the four screws on the top and bottom of the display frame that
mount the display assembly to the chassis.
7. Remove the display frame, filter, and filter retainer.
8. Remove the LCD display and bracket by pulling it out from left side.
Display assembly
Figure 6-16: Display assembly removal
9. To install, do this procedure in the reverse order.
Display Assembly