Filter
Top Products
Removal and Installation Procedures
AWG710 Service Manual
6-23
No tools are needed for this procedure.
1. Locate the modules to be removed in Figure 6–2, page 6–12.
2. Orient the generator so the rear is on the work surface and the bottom is
facing you.
3. Remove the front cover by grasping it by the left and right edges and snap it
off of the front subpanel. When installing, align and snap back on. See
Figure 6–9.
Output panel
Menu buttons
Trim Ring. When removing the
trim ring, grasp its back edge
and vigorously flex it upward
before pulling it forward.
Figure 6-9: Trim ring and menu buttons removal
Trim Ring