Filter
Top Products
Removal and Installation Procedures
AWG710 Service Manual
6-17
Procedures for External Modules
Do the Accsess Procedure on page 6–16 before performing any of the procedures
in this subsection.
The following procedures are listed in the order presented.
H Front Panel Knobs
H Line Fuse and Line Cord
H EMI Gaskets
H Cabinet
H Trim Ring
H A20 Front Panel Assembly
H Output Assembly
H Cabinet Modules
You will need angled-tip tweezers
(Table 6–4, Item 10).
1. Find the knob(s) to be removed on the front panel.
2. Orient the waveform generator so the bottom is on the work surface and the
front is facing you.
3. Remove the knob(s) by pulling it straight out from the front panel to create
some clearance between the base of the knob and the front panel. Insert the
tweezers between the knob and the front panel and remove the knob. See
Figure 6–6.
4. To install, align the knob to the shaft and push in until it snaps into place.
Front Panel Knobs