Filter
Top Products
Preparation for Use
AWG710 Service Manual
2-9
The instrument automatically runs power-on self tests to check that the instru-
ment is operating normally.
Check the results of the power-on self tests. If all the diagnostic tests are
completed without error, the instrument displays Pass and then the SETUP menu
screen.
If the system detects an error, the instrument displays Fail and the error code
number on the screen. You can still operate the instrument if you exit this state,
but the wave output accuracy is not guaranteed until the error is corrected. To
exit the diagnosis mode, push any button. The system goes to the SETUP menu
screen.
NOTE. Contact your local Tektronix Field Office or representative if the
instrument displays an error message. Make sure to record the error code
number.
Power off the AWG710 Arbitrary Waveform Generator by toggling the ON/
STBY switch to the STBY position and turning the PRINCIPAL POWER
SWITCH on the rear panel to OFF.
WARNING. To prevent electrical shock, remove all power from the instrument,
turn the PRINCIPAL POWER SWITCH on the back panel to OFF, and
disconnect the power cord from the instrument. Some components in the AWG710
Arbitrary Waveform Generator are still connected to line voltage after turning
off the instrument from the front panel ON/STBY button.
To prevent loss of data and/or damage to the hard disk, before the power off,
confirm that the hard disk LED on the lower right of the front panel does not
light or blink.
PowerĆOn Diagnostics
Power Off