Filter
Top Products
Operating Basics
2-32
AWG710 Service Manual
You can delete a file or directory by doing the following steps:
NOTE. You cannot delete a file or directory if the file or directory is set to ’read
only’. Also, you can only delete a directory if the directory is empty.
1. Push EDIT (front).
The instrument displays the file list.
2. Select the file to delete.
3. Push File (bottom)!Delete (side). The instrument displays a message box
asking you to confirm deleting the file.
4. Push OK (side) to delete the file or Cancel to cancel the operation and keep
the file.
You can also delete all files on the current drive and directory by doing the
following steps:
1. Push EDIT (front)!File (bottom)!Delete All (side).
The instrument displays a message box asking you to confirm deleting all
files.
2. Push OK (side) to delete all files or Cancel to cancel the operation and keep
all files.
To change the read only or read/write attributes on a file, do the following steps:
1. Push EDIT (front).
The instrument displays the file list.
2. Select the file to change the attribute.
3. Push File (bottom)!Attribute xxxx (side).
The xxxx is the Read/Write or Read Only attribute of the selected file. Pushing
this side button immediately changes the file attribute.
Files with a read only attribute are identified by
icon, and the directories by
icon. See Figure 2–17.
Deleting Files
Read Only Attribute