Filter
Top Products
Operating Basics
2-34
AWG710 Service Manual
NOTE. When you exit an editor without saving edited data, the instrument
displays the message Save the changes you made? Push the Yes side button to
save the waveform data.
To save waveform data to a new file name, push File (bottom)!Save As
(pop-up)!OK (side). The instrument opens the Input Filename dialog box as
shown in Figure 2–18. Use this dialog box to enter a file name. If necessary, you
can select a storage media or directory by pushing the Drive... side menu button.
When you are done entering the file name, push the front panel ENTER button
to close the dialog box and save the file.
If you are saving a file with a record length larger than 64 data points, the
instrument needs to adjust the record length to meet internal memory record
length requirements. The instrument displays one of the messages shown in
Table 2–10. Select one of the messages and push the OK side button to accept
the recommended change or cancel the save and then edit the file to satisfy the
data record length requirements.
Table 2-10: Waveform record length adjustment messages
Message Description
Leave it as is The data is saved, as is, without making changes. The instrument will
display an error message if you try to load a file that does not meet the
instrument waveform constraints.
Append 0 With LevelĆ0 data added after the data, a file with a data length meeting
the requirements is created.
Expand With the waveform data expanded, a file with a data length meeting the
requirements is created.
Expand with Clock With the waveform data expanded, a file with a data length meeting the
requirements is created. In addition, the clock frequency increases
without change in scaling factor. The settings are saved in the file.
Repeat With repetitions of the original data linked, a file with a data length
meeting the requirements is created.
To archive or extract files, do the following steps.
Archive. When you select Directory in the file list, you can make archives for all
the files in the directory and subdirectory.
1. Push EDIT (front).
The instrument displays the file list.
2. Select the file to make archive files.
Archive, Extract