Filter
Top Products
Operating Basics
AWG710 Service Manual
2-17
Power supply fuse holder
The 10 A fast blow and5A(T)
fuse are used for 115 V and
230 V systems, respectively.
Power connector
Connect the provided power cable to this
connector.
100/10BASEĆT connector
IEEE STD 488 connector
Connect to the Ethernet
network.
KEYBOARD connector
DISPLAY MONITOR OUT
connector
Inputs external event signals. This
signal can be used for sequence
control in Enhanced mode.
PRINCIPAL POWER SWITCH
Applies power to all circuits. In addition to
this switch being on, the front panel
ON/STBY switch must also be turned on.
EVENT IN connector
1/4 CLOCK OUT connector
The internal 10 MHz clock reference signal is output when the
internal clock reference is selected. The external clock reference
signal is output when the external clock reference is selected.
The maximum output level is 1 V
pkĆpk
"0.1V into 50 W load
1/4 Sampling clock signal output.
10 MHz REF OUT connector
TRIG IN connector
External trigger signal
input.
10 MHz REF IN connector
External 10 MHz reference
clock signal input.
A GPIB connector for remote
computer control through an
IEEE 488 standard parallel interface.
Connect to an external monitor.
Connect to a standard PC
101Ćkey keyboard.
Figure 2-6: Rear panel signal and power connectors