Filter
Top Products
Removal and Installation Procedures
AWG710 Service Manual
6-25
FrontĆPanel assembly
Back of
Front-panel
assembly
P3
P2
To J154
on the Connector
board
Figure 6-10: A20 Front panel assembly removal
If the front panel or the front panel buttons need service, do the following steps:
7. Remove the front panel control knobs from the front panel assembly using
the method described in Front Panel Knobs on page 6–17.
8. Remove the eight screws that mount the front panel board to the front panel.
9. Hand disassemble the front panel assembly components using Figure 6–11
as a guide. Do this procedure in reverse order to reassemble using Fig-
ure 6–11 as a guide.
10. To install, reverse this procedure.