Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

File System Commands

XSR CLI Reference Guide 3-107

Example

XSR#show whoami

Sample Output

XSR#show whoami

Comm Server “Enterasys”, current line at 9600bps.

File System Commands

TheXSRemploysanMS‐DOS‐compatiblefilesysteminFlashmemory.Thefollowingcommands

areavailable.

boot system

Thiscommandcreatesaboot-config filetostorethefirmwarefilenameoftheactivesoftware

image.Thisfilenamepointstothefirmwarefileloadedduringsysteminitializationinthe

followingsequence:

1. Theboot‐configfileislookedupineitherflash:orcflash:

•Ifboot‐configisnotfoundthere,therouterproceedsto

Step2.

•Ifthefilenamedinboot‐configisnotfound,theroutergoestoStep3.

2. Ifthedefaultfile(

xsr1800.flsorxsr3000.fls)isnotfound,theroutergoestoStep3.

3. AnFTP/TFTPserverasdefinedinnetworkparametersofBootrommodeisqueried.Ifthe

imageisnotfoundinthisremotelocation,initializationissuspendedinBootrommode.

Thecommandinitiatesascriptrequiringconfirmationofyourintention.

Syntax

boot system <newName.FLS>

Mode

Global configuration: XSR(config)#

Default

• XSR1800.FLS‐forSeries1800routers

• XSR3000.FLS‐forSeries3000routers

Examples

ThefollowingXSR1800Seriesexamplecreatesaboot-configfilepointingtothefirmwarefile

name

VPN_XSR1800.fls:

XSR(config)#boot system VPN_XSR1900.fls

ThefollowingexamplerenamestheVPN_XSR1900.flsfiletomatchthe Bootromdefaultfile

name.Afterenteringthecommand,youarepromptedbythefollowingscript:

Note: A new software image file name must use the .fls extension. Optionally, you can modify a file

with the rename command.

previous next