Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

Book Title goes here 11-83

11

ISDN BRI and PRI Commands

Observing Syntax and Conventions

TheCLISyntaxandconventionsusethenotationdescribedinthefollowingtable.

ISDN Commands

ThefollowingsetofcommandsallowsyoutoconfigureBRI/PRIfunctionalityontheXSR.

interface bri

ThiscommandconfiguresaBRIinterfaceforeachphysicalBRIportontheBRINIMcard.When

entered,the

interface bri commandmustbefollowedbytheisdn switch-typecommandfor

BRIISDNapplications,orthe

leased-line bricommandforBRIleasedlineapplications.Ifnone

oftheabovecommandsareissuedBRIportsarenon‐operational.

Syntax

interface bri board/slot/port

Convention Description

xyz Key word or mandatory parameters (bold)

[x] [ ] Square brackets indicate an optional parameter (italic)

[x | y | z] [ | ] Square brackets with vertical bar indicate a choice of values

{x | y | z} { | } Braces with vertical bar indicate a choice of a required value

[x {y | z} ] [{ | } ] Combination of square brackets with braces and vertical bars indicates

a required choice of an optional parameter

(config-if<xx>) xx signifies the interface type and number; e.g., F1, G3, S2/1.0, M57, BRI-

1/1, PRI-2/1. F indicates a FastEthernet, and G a GigabitEthernet

interface.

Next Mode entries display the CLI prompt after a command is entered

soho.enterasys.com Italicized, non-syntactic text indicates either a user-specified entry or text with

special emphasis

board/slot/port

BRIboard,slot,andportnumbers.Forleased‐lineapplications:1forB1

and2forB2.Sub‐portsareaddedbytheleased-line [56 | 64]

command.

previous next