Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

Hardware Controller Commands

4-90 Configuring Hardware Controllers

• Speedcannotbechangedinloopbackmode.

•Whenconnectingan

autosettingonanXSRtoaforcedsettingonanotherrouter,theforced

settingmustbesetto

half-duplexregardlessofthespeed(10or100Mbits).

•ForGigabitEthernetonly,youmustuseacross‐overcablewhenoneorbothendsofalineare

forced.Ifbothendsofthelineare

autothenyoumayuseacross‐overorstraight‐through

cable.

•WhentheGigabitFiberportisinuse,bothduplexandspeedmustbesettoautoonbothends

ofthelineotherwisetheconnectionisunpredictable.

Syntax

speed {10 | 100 | auto}

Syntax of the “no” Form

no speed

Mode

Interfaceconfiguration:XSR(config-if<Fx>)#

Default

Auto

Example

XSR(config-if<S1/0>)#speed auto

XSR(config-if<S1/0>)#duplex auto

stopbits

Thiscommandsetsthenumberofstop‐bitsonaserialport.Itisvalidandtakeseffectonlywhen

theinterfaceisrunninginasynchronousmode.

Syntax

stopbits {1 | 2}

Syntax of the “no” Form

no stopbits

10

Forcestheinterfacetooperateat10Mbitspersecond.

100

Forcestheinterfacetooperateat100Mbitspersecond.

auto

Allowstheporttosetthespeedand duplexmodeautomatically.

1

Onestopbit.

2

Twostopbits.

previous next