PPP Configuration Commands
13-100 Configuring ADSL
Syntax of the “no” Form
Thenoformofthiscommandreturnsthisparametertoitsdefaultsetting:
no ppp keepalive
Mode
ATMSub‐Interfaceconfiguration:XSR(config-if<ATMx/x/x.x>)#
Defaults
• Disabled
•Keepaliveperiod:30seconds
Example
Thisexampleenablesthekeepalivemechanismandsetsthetimebetweenmessagesto20seconds:
XSR(config-if<ATM0/1/0.1>)#ppp keepalive 20
ppp lcp
ThiscommandconfiguresLinkControlProtocol(LCP)parametersforPPP.Itrequiresaproperly
configuredATMsub‐interfacespecifyingencapsulationtypePPPoAorPPPoE.
Syntax
ppp lcp {max-configure <count1> | max-failure <count2> | max-terminate <count3>}
Syntax of the “no” Form
Thenoformofthiscommandreturnsthisparametertoitsdefaultsetting:
no ppp lcp
Mode
ATMSub‐Interfaceconfiguration:XSR(config-if<ATMx/x/x.x>)#
Defaults
• Configure‐Requests:10
• Configure‐Nak:5
• Terminate‐Requests:2
max-configure count1
PeaknumberofConfigure‐Requeststosend.Range:1to255.
max-failure count2
PeaknumberofConfigure‐Nakpacketstosend.Range:1to255.
max-terminate count3
PeaknumberofTerminate‐Requeststosend.Range:1to255.