Filter
Top Products
Hardware Controller Clear and Show Commands
XSR CLI Reference Guide 4-105
Sent: 0 octets, 0 unicast packets,
0 discards, 0 errors.
MTU is 1500 bytes.
Proxy ARP is enabled.
Helper address is not set.
Directed broadcast is enabled.
Outgoing access list is not set.
Inbound access list is not set.
IP Policy Based Routing is not enabled.
Thefollowingexampleissampleoutputfromtheshow interface null 0command:
XSR#show interface null 0
Null0 is Admin Up
Internet address is not assigned
show interface serial
Thiscommanddisplaysgeneralinformationforaserialinterface.
Syntax
show interface serial [card/port]
Mode
PrivilegedEXECorGlobalconfiguration:XSR# orXSR(config)#
Sample Output
ThefollowingexampledisplaysoutputfromSerialinterface1/0:
XSR#show interface serial 1/0
********** Serial Interface Stats **********
Serial 1/0 is Admin Down / Oper Down
Internet address is 200.163.21.1
The name of this device is Ser1/0.
The card is 1.
The channel is 0.
The current MTU is 1500.
The device is in polling mode, and is ACTIVE.
The last driver error is (null).
The physical-layer is HDLC-SYNC.
The baud rate is estimated to be 1024000 bits/sec.
The device uses CRC-16 for Tx.
The device uses CRC-16 for Rx.
The type of encoding is NRZ.
The media-type is RS-232/V.28 (DTE).
The loopback mode is off.
Other Interface Statistics:
card
XSRcardnumberofserialinterface.
port
XSRportnumberofserialinterface.