Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

Other ADSL Commands

13-98 Configuring ADSL

no shutdown

ThiscommandsetstheATMinterfacetotheadministrativeUpstateandenablesthelinefor

operation.Datatrafficcannotflowuntilatleastoneassociatedsub‐interfaceissettothe

administrativeUpstate.Issuingthiscommanddoesnotchangetheadministrativestateofsub‐

interfacesassociatedwiththisATM

interface.

ThiscommandsurveysthestatusoftheDSPfirmware(whichwasloadedandstartedatboot

time)andifitfindsitinanillegalstate(i.e.,crashed),itreloadsandrestartstheDSPfirmware

beforeproceedingwiththe

no shutdownoperation.DependingonthesizeoftheDSPfirmware

andcharacteristicsofthedownl oadprocess,thisoperationmaytakeanoticeablelengthoftime.

Syntax

no shutdown

Mode

ATMInterfaceconfiguration:XSR(config-if<ATMxx>)#

Example

ThefollowingexamplesetstheATMinterfacetotheadministrativeupstate:

XSR(config-if<ATM0/1/0>)#no shutdown

shutdown

ThiscommandsetstheATMinterfacetotheadministrativeDownstate.Asaresult,allATMsub‐

interfacesassociatedwiththisATMinterfaceareshutdown,alldatatrafficisstoppedandtheline

disabled.

Syntax

shutdown

Syntax of the “no” Form

Refertono shutdownonpage13‐98.

Mode

ATMInterfaceconfiguration:XSR(config-if<ATMxx>)#

Example

ThefollowingexamplesetstheATMinterfacetotheadministrativedownstate:

XSR(config-if<ATM0/1/0>)#shutdown

previous next