Enterasys Networks XSR CLI Router User Manual


 
Hardware Controller Clear and Show Commands
4-102 Configuring Hardware Controllers
The Name of the Access Concentrator is c3600-1
The Session Id is 0x0005
The MAC Address of the Access Concentrator is 0x00:30:85:20:47:62
The MTU is 1492
Other Interface Statistics:
ifOperStatus 1
ifInOctets 119439
ifOutOctets 119256
Configured VLANs:
VLAN Id 1400
PPP Encapsulation
show interface gigabitethernet
ThiscommanddisplaysinformationaboutaGigabitEthernetinterfacewhichisavailableonXSR
3000Seriesroutersonly.
Syntax
show interface gigabitethernet [number]
Mode
PrivilegedEXECorGlobalconfiguration:XSR# orXSR(config)#
Sample Output
ThefollowingexampleissampleoutputfromGigabitEthernetinterface1:
XSR#show interface gigabitethernet 1
GigabitEthernet 1 is Admin Up
Internet address is 150.50.1.14, subnet mask is 255.255.255.0
The name of this device is Eth1.
The physical link is currently DOWN.
The active port is copper.
The device is in polling mode, and is active.
The last driver error is '(null)'.
The duplex mode is set to auto-negotiated.
The current operational duplex mode is not yet determined.
The speed is set to auto-negotiated.
The current operational speed is not yet determined.
The Primary MAC address is (in hex) 00:01:f4:2b:3e:1b.
The MTU is 1518.
The bandwidth is 10 Mb/s.
Other Interface Statistics:
ifindex 0
ifType 6
ifAdminStatus 1
ifOperStatus 2
number
TheGigabitEthernetinterface,rangingfrom1to3,andsubinterface.Range:1to64.