Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

Multilink PPP Commands

8-120 Configuring the Point-to-Point Protocol

Syntax

multilink load-threshold number (1-255)

Default

255

Mode

DialerInterfaceconfiguration:XSR(config-if<xx>)#

Example

ThefollowingexamplesetsthemultilinkPPPloadthresholdto250ontheterminatingDialer

interface:

XSR(config)#interface dialer 4

XSR(config-<D4>)#multilink load-threshold 250

ppp multilink multi-class

ThiscommandenablesMulti‐ClassMLPPP(MultilinkPPP)fortheMultilinkPPPheaderformat

providingQualityofService(QoS)forselectedpacketsbetweenpeers.Itsupportsfivestreamsof

sequencenumbers,thelongsequenceformatbydefault,andtheshortsequencenumberby

negotiation.Anyclasslowerthanthedefaultrequested

bythepeerwillbeaccepted,andhigher

thanthedefaultwilleventuallytriggerarejectmessageifthevalueisacceptedbythepeer.

Syntax

ppp multilink multi-class

Syntax of the “no” Form

Thenoformofthiscommanddisablesmulti‐classMLPPP:

no ppp multilink multi-class

Defaults

• Longsequencenumber

• Acceptnegotiationforshortsequencenumber

• Acceptanysuspendable(class)levellessthanorequalto5

• Disabled

Mode

DialerorMultilinkInterfaceconfiguration:XSR(config-if<xx>)#

1-255

Loadontheport:255indicatesithasreached100%ofbandwidth.

previous next