Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

Dialer Interface Commands

10-84 Configuring the Dialer Interface

•Thedialer stringcommandmustbesettothedialerinterfacethatownsthedialerpool

wherethedialerDTRserialinterfaceisadded.

•Theserialinterfacemustbeconfiguredforsynchronousdatamode.

•ThemodemmustbeconfiguredwithDTR‐controlleddialinginterface,CTSfollowsDCD,

DTRdisconnects,syncdatamodeanda

presetdialingouttelephonenumber.

Syntax

dialer dtr

Syntax of the “no” Form

no dialer dtr

Default

DTRdialingisdisabled

Mode

Interfaceconfiguration:XSR(config-if<xx>)#

Example

XSR(config-if<S1/1>)#dialer dtr

dialer pool

Thiscommandspecifieswhichdialerpoolthedialerinterfaceshoulduse.Thedialerinterfacewill

useoneofthephysicalinterfacesinthe dialerpooltoatt achtotheinterfaceʹsconfigured

destination.

Syntax

dialer pool number

Syntax of the “no” Form

no dialer pool

Default

Disabled‐nopoolisspecified.

number Dial pool number, ranging from 1 to 255.

previous next