Filter
Top Products
OSPF Debug and Show Commands
XSR CLI Reference Guide 5-119
show ip ospf interface
ThiscommanddisplaysinterfaceOSPF‐relatedinformation,includingnetworktype,priority,
cost,hello,interval,deadinterval.
Syntax
show ip ospf interface [type][number]
Mode
EXECorGlobalconfiguration: XSR> or XSR(config)#
Sample Output
Thefollowingaresampleresponses:
XSR>show ip ospf interface
FastEthernet1 is UP
Internet Address 51.51.51.1 Mask 255.255.255.0
Internet Address 52.52.52.1 Mask 255.255.255.0 secondary
Internet Address 53.53.53.1 Mask 255.255.255.0 secondary
Area 0.0.0.2
Router ID 51.51.51.1,Network Type BROADCAST,Cost: 10
Transmit Delay is 1 sec,State DR,Priority 1
Designated Router id 51.51.51.1, Interface addr 51.51.51.1
No backup designated router on this network
Timer intervals configured, Hello 10,Dead 40,Wait 40,Retransmit 5
No Hellos (Passive Interface)
Neighbor Count is 0, Adjacent neighbor count is 0
Parameter Descriptions
ASexternal SumofexternalLSrecords.
Subtotal SubtotalSumofLSrecordsperarea.
Delete SumofLSrecordswaitingfordeletionfromLSDB.
Maxage SumofLSrecordsthathavereachedmaximumage.
Total SumofLSrecordsintheLSdatabaseonXSR.
type
Interfacetype.Validinterfacetypesareinterfacesthatexistonthisrouter.
number
Interfacenumber.Validvaluescorrespondtothenumberofaparticular
interfacetypepresentonthisrouter.
Internetaddress IPaddressandmaskassignedtothisinterface.
Area OSPFareatowhichthisinterfaceisassigned.
RouterID OSPFrouterID.OSPFselectstheRouterIDfromoneoftheIP
addressesconfiguredonthisrouter.
NoHellos(Passive
Interface)
OSPFHellosarenotsentorreceivedonthisinterface.