Filter
Top Products
Frame Relay Commands
9-88 Configuring Frame Relay
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#no shutdown
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay intf-type dte
XSR(config-if<S1/0>)#frame-relay lmi-type ansi
ThefollowingexampleconfiguresSerialinterface1/0toactasaFrameRelayDCE,andtousethe
ANSIAnnex‐DLMI:
XSR(config)#interface serial 1/0
XSR(config-if<S1/0>)#no shutdown
XSR(config-if<S1/0>)#encapsulation frame-relay
XSR(config-if<S1/0>)#frame-relay intf-type dce
XSR(config-if<S1/0>)#frame-relay lmi-type ansi
frame-relay lmi-t391dte
ThiscommandsetstheintervalbetweenLMILinkIntegrityVerification(LIV)message
transmissionsontheDataTerminalEquipment(DTE )interface.
Syntax
frame-relay lmi-t391dte period_in_sec
Syntax of the “no” Form
Usethenocommandtorestorethedefaultintervalvalue:
no frame-relay lmi-t391dte
Default
10
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
Refer to the example in the lmi-n391dte command on page89.
Note: On third-party devices, the LMI LIV period may be configured using the KeepAlive
configuration on the interface.
period_ in_sec
SetstheintervalbetweenLMILIVpolls,rangingfrom5to330seconds.