Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

General Network Management Commands

1-12 Network Management

•Width:132characters

•0meansnolimit

Example

XSR#terminal width 40

XSR#terminal length 40

traceroute

ThiscommandgathersinformationregardingtheroutethatIPdatagramsfollowtoaspecified

destination.Thisimplementationofthe

tracerouteutilityusesUDPasthetransportlayer.It

transmitsthreeprobesforeachhopbetweensourceanddestination.

Syntax

traceroute dest-addr [source-addr]

Mode

EXEC:XSR>

Defaults

•Maximumintervaltowaitforaresponse:3seconds

•Maximumintervaltolive:30seconds

• Packetsize:40bytes.

Sample Output

XSR>traceroute 140.252.13.65 172.15.57.99

traceroute to 140.252.13.65,30 hops max,40 bytes packets

1. 140.252.13. 3520 ms 10 ms 10 ms

2. 140.252.13. 65120ms 120ms 120ms

Parameters in the Response

Aprobetimeoutissignaledbyanasterisk”*”.

Abnormal Termination Signs

!P‐ProtocolUnreachable

!N‐NetworkUnreachable

!H‐HostUnreachable

dest-addr

Networkaddressofthedestination.

source-addr

Sourceaddressforthepingpacket.Ifthisisnotset,theRouterIDisused.

previous next