Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

DOD/BOD Commands

XSR CLI Reference Guide 10-99

Syntax of the “no” Form

Thenoformofthiscommanddisablesthefeature:

no dialer caller number

Mode

DialerInterfaceconfiguration:XSR(config-if<Dx>)#

Example

Thefollowingexampleconfiguresthedialercallernumberstoscreen:

XSR(config)#interface dialer 1

XSR(config-if<D1>)#dialer caller 5084712345

dialer idle-timeout

ThiscommandspecifiestheidletimeoutintervalbeforetheXSRdisconnectstheline.Thetimeout

triggerisbasedonoutboundtrafficonly.

Syntax

dialer idle-timeout seconds

Syntax of the “no” Form

Usethenoformofthiscommandtoresettheidletimeouttothedefault:

no dialer idle-timeout

Mode

DialerInterfaceconfiguration:XSR(config-if<Dx>)#

Default

120seconds

Examples

Thefollowingexampleresetstheidle‐timeout:

Note: If the ISDN switch does not provide the calling number, callback will fail.

Caution: This command must be invoked on the called side of a link with a 0 value to ensure the

link is not dropped after 120 seconds by the called side.

seconds Interval before disconnecting the line, ranging from 0 to 2,147,483 seconds.

Specifying 0 disables the timeout.

previous next