Filter
Top Products
Hardware Controller Clear and Show Commands
XSR CLI Reference Guide 4-95
Syntax
clear interface serial [card/port]
Mode
PrivilegedEXEC:XSR#
Example
XSR#clear interface serial 1/0
show controllers fastethernet
ThiscommanddisplaysdetailedFastEthernetcontrollerdataforaport.Thisinterfaceisavailable
ontheXSR1800Seriesroutersonly.
Syntax
show controllers fastethernet number
Mode
PrivilegedEXECorGlobalconfiguration:XSR# orXSR(config)#
Sample Output
ThefollowingexampledisplaysoutputfromFastEthernetport1:
XSR(config)#show controllers fastethernet 1
Packet Processor Tx Scheduler Stats:
157 Packet driver Tx OK
0 Packet driver not Tx: MUX END_ERR_BLOCK
0 Packet driver not Tx: MUX ERROR
0 Packet driver not Tx: Unknown Msg from MUX
The unit number is 1.
The interrupt number is 15.
Memory: base = 0xef600800
Vars: PollCount = 2806, g_eth1Interrupt = 0, bRxRunning = 0
Vars: bTxClean = 0, outQHung = 0
[...]
TX RING ENTRIES:
The ring starts at 0x01fcd000.
TxDRNum = 256, pTxMblkDR = 0x005f4824, TxDRIdx = 0
TxDRCleanIdx = 0
dataLen 0x00000000, status 0x00001300, buffer 0x00000000
card
XSRcardnumber.
port
XSRportnumber.
number
FastEthernetinterfacenumber,rangingfrom1to2.