Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

Multilink PPP Commands

XSR CLI Reference Guide 8-111

XSR(config-if<D57>)#ppp bap call accept

ppp bap callback

ThiscommandsetsenablesBandwidthAllocationProtocol(BAP)callbackparametersonadialer

interfacetosetupBandwidth‐on‐Demand(BoD).Itpermitstheporttoinitiateaddingalinktoor

requestingalinkfromapeer.ItappliestoDialerinterfacesonly.

The

multilink load-thresholdcommandisasecondmeansbywhichtheXSRcontrolstraffic

viaBoD.Itisalsoprovidedbysettingthe

multilink min-links command.

Syntax

ppp bap callback {accept | request}

Mode

DialerInterfaceconfiguration:XSR(config-if<Dx>)#

Mode of the “no” Form

Thenoformofthiscommandremovescallbackconfiguration:

no ppp bap callback {accept | request}

Example

ThefollowingexampleconfiguresBAPtoacceptandrequestcallbacks:

XSR(config)#interface dialer 1

XSR(config-if<D1>)#encapsulation ppp

XSR(config-if<D1>)#no shutdown

XSR(config-if<D1>)#ppp bap callback accept

XSR(config-if<D1>)#ppp bap callback request

ppp bap number

ThiscommandspecifiestheBandwidthAllocationProtocol(BAP)phonenumberwhichapeer

candialtoconnectandsetupBandwidth‐on‐Demand(BoD).Itapplies todialerinterfacesonly.

The

multilink load-thresholdcommandisasecondmeansbywhichtheXSRcontrolstraffic

viaBoD.Itisalsoprovidedbysettingthe

multilink min-links command.

Note: You must configure multilink load-threshold to run BAP.

accept

Localrouterinitiatesalinkadditionuponpeernotification.

request

Localrouterrequestsapeertoinitiatealink.

Note: The multilink load-threshold command must be set to operate BAP.

previous next