Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

PPP Commands

XSR CLI Reference Guide 8-85

Syntax

interface type slot_num card_num port_num sub-interface_num

Slots,cards,ports,andsub‐interfacesareexpressedasfollowsontheCLI:

Syntax of the “no” Form

Thenocommanddeletestheinterface:

no interface serial port_num interface_num

Mode

Globalconfiguration:XSR(config)#

Examples

Thisexampleselectsinterfaceserial1/0andsetsPPPencapsulation:

type

ATM,BRI, Dialer,Fast/GigabitEthernet,Loopback,Multilink,SerialorVPN

port.

slot_num

TheNIMnumberrangingfrom0to6dependingontheXSRmodel.

card_num

TheNIMcardnumberrangingfrom1to2dependingontheNIMinstalledin

theslot.

port_num

Thephysicalportnumberrangingfrom:0(ATM),0to1(BRI),0to255(Dialer

&VPN),0to15(Loopback),1to32767(Multilink),0to3(Serial),1to2

(FastEthernet),1to3(GigabitEthernet),and0(Console).

IfaSerialportresidesonaT1/E1port,then

channelgroupdatamustbe

addedattheendofthestringtomarkwhichchannelgroupoftheT1/E1port

willbeset:

card_num/NIM_num/port_within_NIM:[channel‐group_num].

Forexample,0/2/1:15setschannel‐group15oftheT1orE1port1inNIMslot

2onthemotherboard.

sub-

interface_num

Numberrangingfrom1to30(ATM,BRI&Serial),and1to64(Fast/

GigabitEthernet).

0

Theconsoleport.(OnlyontheXSR1800series)

<0-0>/<1-2>/<0-3>

Slot,card,andportnumber.

<1-2>/<0-3>

Cardandportnumber.

<1-2>/<0-3>.<1-30>

Card,portandsub‐interfacenumber.

<1-2>/<0-3>:<0-31>

Card,portandchannelnumber.

<1-2>/<0-3>:<0-31> .<1-30>

Card,port,channelandsub‐interfacenumber.

Note: Leading zeros defined in interface_num can be omitted. For example, 0/1/2 is equivalent to 1/2.

Note: You cannot directly delete a Serial interface assigned to a T1/E1 channel group. You must

instead delete a channel group to delete the Serial port.

previous next