Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

DOD/BOD Commands

10-98 Configuring the Dialer Interface

Example

ThefollowingexamplemapsACL1350todialerlist57:

XSR(config)#access-list 57 permit ip 0.0.0.0 255.255.255.255 255.255.255.255 0.0.0.0

XSR(config)#dialer-list 57 protocol ip list 1350

dialer called

Thiscommandmapsincomingcallstooneofthedialerinterfaces.Amaximumnumberof32

callednumbersperdialerinterfacecanbeconfigured.

Syntax

dialer called DNIS:subaddress

Syntax of the “no” Form

Thenoformofthiscommandremovestheconfigurednumber:

no dialer called DNIS:subaddress

Mode

DialerInterfaceconfiguration:XSR(config-if<Dx>)#

Example

ThefollowingexampleconfiguresadialerprofileforareceiverwithDNIS12345andISDN

subaddress6789:

XSR(config)#interface dialer 1

XSR(config-if<D1>)#dialer called 12345:6789

dialer caller

ThiscommandconfigurescallerIDscreeningwithanoptionprovidingISDNcallback.TheXSR

willacceptcallsfromaspecifiedphonenumber.Amaximumof32callernumberscanbesetper

dialerport.

Thecommandmatchesnumbersstartingwiththeleastsignificantdigitsofthecallingnumber,

startingfromthe

lastdigit.TypicallytheISDNswitchdoesnotprovidethecompletecalling

number,onlythelocalnumber(fourtosevenoftheleastsignificantdigits).

ThedialednumbermustbeconfiguredintheDialerinterface.

Syntax

dialer caller number [callback]

DNIS:subaddress Dialed Number Identification Service, or the called party number, a colon, and

the ISDN subaddress.

number Phone number to screen. Limit: 32 characters.

callback Returns the call to the dialer. This option applies to DoD applications and supports

PPP and MLPPP. If used in a backup capacity, set the number of retries to 1.

previous next