Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

ISDN Commands

Book Title goes here 11-87

APRIorBRIportcanhaveonlyoneISDNcalling‐numberentry.ForISDNPRI,thiscommandis

intendedforusewhenthenetworkoffersbetterpricingoncallsinwhichdevicespresentthecaller

number.Whenconfigured,thecallingnumberisincludedintheoutgoingsetupmessage.

Syntax

isdn calling-number calling-number:subaddress

Syntax of the “no” Form

no isdn calling-number

Mode

BRIInterfaceconfiguration:XSR(config-if<BRI-x>)#

Example

Thefollowingexamplespecifies acallingnumberfortheXSR:

XSR(config)#interface bri 1/0

XSR(config-if<BRI-1/0>)#isdn calling-number 5088781234

isdn disconnect

ThiscommandisusedfordebuggingpurposestotestISDNconnectivity.ItsetsupanISDNdata

calltotestcallsetupprocedureswithaCentralOfficeISDNswitchortestequipment.Itisusedto

disconnectacallbeforeautomaticdisconnectoccursin30secondsorifacallis

notdropped.

Syntax

isdn disconnect c/p channel_number

Mode

PrivilegedEXEC:XSR#

Note: There is no mechanism to mark outgoing calls with the Calling Number and Calling

Subaddress for call routing on the receiving end.

calling-number

Numberofthedevicemakingtheoutgoingcall.Onlyoneentryis

allowed.

:subaddress

Extensionofthephonenumber.

Note: Enter this command in Privileged EXEC, not Global configuration mode.

c/p

BRIorPRIportID.

channel_number

BRI:1or2,E1PRI:0to31,T1PRI:0to22.

previous next