Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

ISDN Commands

11-86 ISDN BRI and PRI Commands

Example

ThefollowingexamplesetstheT1controllertomakecallselectionsinascendingorder:

XSR(config)#controller t1 1/0/0

XSR(config-controller<T1-1/0:0>)#description “T1 at Acme”

XSR(config-controller<T1-1/0:0>)#framing esf

XSR(config-controller<T1-1/0:0>)#linecode b8zs

XSR(config-controller<T1-1/0:0>)#pri-group

XSR(config-controller<T1-2/1>isdn bchan-number-order ascending

isdn call

ThiscommandisusedfordebuggingpurposesonlytotestcallsetupprocedureswithaCentral

OfficeISDNswitchortestequipment.Itisautomaticallydisconnectedafter30seconds.

Syntax

isdn call c/p [board/slot/port] dialing-string [56 | 64]

Mode

PrivilegedEXEC:XSR#

Example

ThefollowingexampleinitiatesanISDNcallonBRIport2/1at56kbps:

XSR#isdn call 2/1:61712345678 56

<186>Jul 28 22:49:51 10.10.10.20 ISDN:

No Channel Available For Test Call

isdn calling-number

ThiscommandconfiguresanISDNPRIorBRIinterfacetoincludecaller‐numberintheout‐going

setupmessage.ThisbillingnumberisusedfornonFullyInitializingTerminals(FIT)outside

NorthAmericaonlybecausethe

isdn spid1/2commandalreadyconfigurestheLDN.

Note: Enter this command in Privileged EXEC, not Global configuration mode.

c/p

BRIorPRIportID.

dialing-string

Calledphonenumberandsub‐address.

56

Callplacedat56kbpsrate.

64

Callplacedat64kbpsrate.

previous next