Filter
Top Products
Dialer Interface Commands
XSR CLI Reference Guide 10-85
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
Thefollowingexampleshowsdialerinterface0assignedtodialerpool6.
XSR(config)#interface dialer 0
XSR(config-if<D1>)#dialer pool 6
XSR(config-if<D1>)#no shutdown
dialer pool-member
Thiscommandconfiguresphysicalinterfacesfordialdevicesonly.
Syntax
dialer pool-member number [priority priority]
Syntax of the “no” Form
no dialer pool-member number
Defaults
•Disabled.Whenenabled,nodefaultdialing poolnumberisassigned
•Priority:0
•Minimum:0
•Maximum:255
Mode
Interfaceconfiguration:XSR(config-if<xx>)#
Example
Thefollowingexampleshowsaserialinterfacebelongingtotwodialerpoolswithpriorities
configuredforeachpool:
XSR(config-if)#interface serial 1/0
XSR(config-if<S1/0>)#dialer pool-member 1 priority 10
XSR(config-if<S1/0>)#dialer pool-member 2 priority 20
XSR(config-if<S1/0>)#no shutdown
Note: This command is intended for dialer interfaces only.
number Dialpool number ranging from 1 to 255.
priority Priority of the interface within the dialing pool - ranging from 0 (lowest) to 255
(highest). Ports with the highest priority are selected first for dialing out.