Support User Manuals

Enterasys Networks XSR CLI Router User Manual

Open as PDF

of 684

Dialer Interface Commands

10-86 Configuring the Dialer Interface

dialer string

Thiscommandcreatesastringusedtoplaceacalladestinationorsubnet.Typically ,itisthe

telephonenumberneededfordialing.

Syntax

dialer string dial-string [class class-name]

Syntax of the “no” Form

no dialer string dial-string

Mode

Interfaceconfiguration:XSR(config-if<xx>)#

Example

Thisexampleshowsthatdialerinterface0configuredtousemap‐classXXXwhenusingdialer

string9055559988:

XSR(config-if)#interface dialer 0

XSR(config-if<D0>)#dialer string 9055559988 class XXX

dialer wait-for-carrier-time (interface configuration)

Thiscommandconfiguresthetimeadialerinterfacewaitsforacarriersignal.Itisusedwhen

configuringaparticulardialerinterface.

Syntax

dialer wait-for-carrier-time seconds

Syntax of the “no” Form

Thenoformofthiscommandresetstodefaultvalue:

no dialer wait-for-carrier-time

Default

60seconds

Mode

Interfaceconfiguration:XSR(config-if<xx>)#

dial-string Phone number to be sent to a dial device.

class-name Map class associated with this dialer string.

seconds Interval the interface waits for a carrier signal when a call is placed via the dial device.

previous next