Chapter 1 Using the NI-DAQ Functions
NI-DAQ FRM for PC Compatibles 1-10
©
National Instruments Corporation
Group Mode
Configure Group
DIG_Grp_Config
Read Group
DIG_In_Grp
Write Group
DIG_Out_Grp
Get Group Status
DIG_Grp_Status
Set Group Mode
DIG_Grp_Mode
Block Transfer
Read Block
DIG_Block_In
Write Block
DIG_Block_Out
Check Block
DIG_Block_Check
Clear Block
DIG_Block_Clear
Set Up Pattern Generation
DIG_Block_PG_Config
Set Up Digital Scanning
DIG_SCAN_Setup
Enable Double Buffering
DIG_DB_Config
Is Half Buffer Ready?
DIG_DB_HalfReady
Transfer To/From Array
DIG_DB_Transfer
SCXI
Load SCXI Configuration
SCXI_Load_Config
Change Configuration
SCXI_Set_Config
Get Chassis Config Info
SCXI_Get_Chassis_Info
Get Module Config Info
SCXI_Get_Module_Info
Read Module ID Register
SCXI_ModuleID_Read
Reset SCXI
SCXI_Reset
Set Up Single AI Channel
SCXI_Single_Chan_Setup
Set Up Muxed Scanning
SCXI_SCAN_Setup
Table 1-3.
The LabWindows/CVI Function Tree for Data Acquisition (Continued)
LabWindows/CVI Function Panel NI-DAQ Function