Filter
Top Products
Appendix A Status Codes
©
National Instruments Corporation A-21 NI-DAQ FRM for PC Compatibles
–10809 gateSignalError Attempted to start a pulse width
measurement with the pulse in the phase
to be measured (for example, high phase
for high-level gating).
–10840 internalDriverError An unexpected error occurred inside
the driver when performing this given
operation.
–10841 firmwareError The firmware does not support the
specified operation, or the firmware
operation could not complete due to a
data-integrity problem.
–10842 hardwareError The hardware is not responding to the
specified operation, or the response
from the hardware is not consistent with
the functionality of the hardware.
–10843 underFlowError Because of system limitations, the
driver could not write data to the device
fast enough to keep up with the device
throughput.
–10844 underWriteError New data was not written to the output
transfer buffer before the driver
attempted to transfer the data to the
device.
–10845 overFlowError Because of system limitations, the
driver could not read data from the
device fast enough to keep up with the
device throughput; the onboard device
memory reported an overflow error.
–10846 overWriteError The driver wrote new data into the input
transfer buffer before the previously
acquired data was read.
–10847 dmaChainingError New buffer information was not
available at the time of the DMA
chaining interrupt; DMA transfers will
terminate at the end of the currently
active transfer buffer.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description