Appendix A Status Codes
NI-DAQ FRM for PC Compatibles A-20
©
National Instruments Corporation
–10783 calConstPolarityConflictError Calibration constants in the load area
have a different polarity from the
current configuration. Therefore, if you
receive this error, you should load
constants from factory. If you receive
status +10783, be aware that NI-DAQ
has automatically loaded constants from
the factory.
–10800 timeOutError The operation could not complete
within the time limit.
–10801 calibrationError An error occurred during the calibration
process.
–10802 dataNotAvailError The requested amount of data has not
yet been acquired.
–10803 transferStoppedError The transfer has been stopped to prevent
regeneration of output data.
–10804 earlyStopError The transfer stopped prior to reaching
the end of the transfer buffer.
–10805 overRunError The clock rate is faster than the
hardware can support. An attempt to
input or output a new data point was
made before the hardware could finish
processing the previous data point. This
condition also can occur when glitches
are present on an external clock signal.
–10806 noTrigFoundError No trigger value was found in the input
transfer buffer.
–10807 earlyTrigError The trigger occurred before sufficient
pretrigger data was acquired.
–10808 LPTCommunicationError An error occurred in the parallel port
communication with the DAQ device.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description