National Instruments 321645c-01 Welding System User Manual


 
Chapter 1 Using the NI-DAQ Functions
©
National Instruments Corporation 1-11 NI-DAQ FRM for PC Compatibles
Set Up Mux Counter
SCXI_MuxCtr_Setup
Set Up Track/Hold
SCXI_Track_Hold_Setup
Control Track/Hold State
SCXI_Track_Hold_Control
Select Gain
SCXI_Set_Gain
Configure Filter
SCXI_Configure_Filter
Select Scanning Mode
SCXI_Set_Input_Mode
Change AI Channel
SCXI_Change_Chan
Scale SCXI Data
SCXI_Scale
Write to AO Channel
SCXI_AO_Write
Set Digital or Relay State
SCXI_Set_State
Get Digital or Relay State
SCXI_Get_State
Get Status Register
SCXI_Get_Status
Set Up Calibration Mode
SCXI_Calibrate_Setup
Change Cal Constants
SCXI_Cal_Constants
Set Threshold Values
SCXI_Set_Threshold
Counter/Timer
DAQ-STC Counters (GPCTR)
Select Ctr Application
GPCTR_Set_Application
Change Ctr Parameter
GPCTR_Change_Parameter
Configure Ctr Buffer
GPCTR_Config_Buffer
Control Ctr Operation
GPCTR_Control
Monitor Ctr Properties
GPCTR_Watch
Am9513 Counters (CTR)
Configure Counter
CTR_Config
Count Events
CTR_EvCount
Table 1-3.
The LabWindows/CVI Function Tree for Data Acquisition (Continued)
LabWindows/CVI Function Panel NI-DAQ Function