National Instruments 321645c-01 Welding System User Manual


 
Appendix A Status Codes
NI-DAQ FRM for PC Compatibles A-16
©
National Instruments Corporation
–10624 delayTrigError The delayed trigger mode is not
supported or is not available in the
current configuration, or no delay
source has been assigned.
–10625 masterTrigError The trigger configuration for the trigger
master is invalid.
–10626 slaveTrigError The trigger configuration for the trigger
slave is invalid.
–10627 noTrigDrvError No signal has been assigned to the
trigger resource.
–10628 multTrigDrvError A signal has already been assigned to
the trigger resource.
–10629 invalidOpModeError The specified operating mode is invalid,
or the resources have not been
configured for the specified operating
mode.
–10630 invalidReadError The parameters specified to read data
were invalid in the context of the
acquisition. For example, an attempt
was made to read 0 bytes from the
transfer buffer, or an attempt was made
to read past the end of the transfer
buffer.
–10631 noInfiniteModeError Continuous input or output transfers are
not allowed in the current operating
mode.
–10632 someInputsIgnoredError Certain inputs were ignored because
they are not relevant in the current
operating mode.
–10633 invalidRegenModeError The specified analog output
regeneration mode is not allowed
for this board.
Table A-1.
Status Code Summary (Continued)
Status Code Status Name Description