Filter
Top Products
Chapter 2 Function Reference — Select_Signal
NI-DAQ FRM for PC Compatibles 2-382
©
National Instruments Corporation
I/O connector because the pin is used for device-to-SCXI communication. Currently, there are
no SCXI modules that require this.
signal =
ND_FREQ_OUT
Use ND_NONE to disable the output on the pin; in other words, to place the pin in high
impedance state.
The signal present on the
FREQ_OUT pin of the I/O connector is the divided-down version of
one of the two internal timebases. Use sourceSpec to specify the divide-down factor.
signal =
ND_RTSI_0 through ND_RTSI_6
Note This information applies to E Series devices only.
When source =
ND_IN_SCAN_START
, the actual signal source on the specified RTSI line
will be
ND_IN_SCAN_START
or
ND_IN_SCAN_IN_PROG
. The default signal source is
ND_IN_SCAN_START
, with source =
ND_IN_SCAN_START
. The following actions will
change the signal source:
• Call the select_signal function with signal =
ND_PFI_7
and
source =
ND_IN_SCAN_START
or
ND_SCAN_IN_PROG
.
source sourceSpec
ND_NONE ND_DONT_CARE
ND_INTERNAL_10_MHZ 1
through
16
ND_INTERNAL_100_KHZ 1
through
16
source sourceSpec
ND_NONE ND_DONT_CARE
ND_IN_START_TRIGGER ND_LOW_TO_HIGH
ND_IN_STOP_TRIGGER ND_LOW_TO_HIGH
ND_IN_CONVERT ND_HIGH_TO_LOW
ND_OUT_UPDATE ND_HIGH_TO_LOW
ND_OUT_START_TRIGGER ND_LOW_TO_HIGH
ND_GPCTR0_SOURCE ND_LOW_TO_HIGH
ND_GPCTR0_GATE ND_POSITIVE
ND_GPCTR0_OUTPUT ND_DONT_CARE
ND_IN_SCAN_START ND_LOW_TO_HIGH