Index
©
National Instruments Corporation I-3 NI-DAQ FRM for PC Compatibles
semi-period measurement application,
2-239 to 2-240
signals on separate gates application,
2-242 to 2-244
bulletin board support, D-1
burst trigger mode, for DAQArb 5411
devices, 2-34
C
Calibrate_1200 function, 2-49 to 2-54
Calibrate_DSA function, 2-55 to 2-57
description, 2-55 to 2-56
performing external calibration of
board, 2-56
performing self-calibration of board, 2-56
restoring factory calibration, 2-57
Calibrate_E_Series function, 2-58 to 2-62
calibration constant loading by
NI-DAQ, 2-62
calibration constants, 2-59
changing default load area, 2-60
description, 2-58 to 2-60
performing external calibration of
board, 2-61
performing self-calibration of board,
2-60 to 2-61
calibration functions
AO_Calibrate, 2-25 to 2-26
Calibrate_1200, 2-49 to 2-54
Calibrate_DSA, 2-55 to 2-57
Calibrate_E_Series function, 2-58 to 2-62
definition, 1-13
LabWindows function panel tree, 1-6
LPM16_Calibrate, 2-279
MIO_Calibrate, 2-280 to 2-283
SCXI_Cal_Constants, 2-322 to 2-329
SCXI_Calibrate_Setup, 2-330 to 2-331
callback function, enabling. See event message
functions.
channel settings. See analog input channel
settings.
Config_Alarm_Deadband function
description, 2-63 to 2-65
high alarm deadband (figure), 2-65
low alarm deadband (figure), 2-66
Config_ATrig_Event_Message function,
2-67 to 2-70
Config_DAQ_Event_Message function,
2-71 to 2-82
callback functions, 2-82
DAQ event messages (table), 2-74 to 2-77
description, 2-71 to 2-73
example, 2-81 to 2-82
usable parameters for DAQ event codes
(table), 2-79
using the function, 2-80 to 2-82
valid counters and external timing signals
for DAQEvent=9 (table), 2-78
configuration functions
AI_Configure, 2-6 to 2-9
AI_MUX_Config, 2-10 to 2-11
AO_Configure, 2-38 to 2-41
Config_Alarm_Deadband, 2-63 to 2-66
Config_ATrig_Event_Message,
2-67 to 2-70
Configure_HW_Analog_Trigger,
2-83 to 2-89
CTR_Config, 2-90 to 2-91
CTR_FOUT_Config, 2-96 to 2-97
DAQ_Config, 2-118 to 2-120
DAQ_DB_Config, 2-121
DAQ_StopTrigger_Config,
2-140 to 2-141
definition, 1-13
DIG_Block_PG_Config, 2-154 to 2-157
DIG_DB_Config, 2-158 to 2-159
DIG_Grp_Config, 2-164 to 2-165
DIG_Line_Config, 2-177
DIG_Prt_Config, 2-183 to 2-185
DIG_SCAN_Setup, 2-188 to 2-191