Filter
Top Products
7-258
TAN(P)
7.12.5 TAN operation on floating-point data (Single precision)
(TAN(P))
TAN (P)
*2: Applicable for the Universal model QCPU only.
Function
(1) Returns the tangent (TAN) value of the angle data designated by , and stores operation
result in device designated by .
(2) Angles designated at are set in radian units (degrees / 180).
For conversion between degrees and radian values, see the RAD and DEG instructions.
(3) When angles designated by are /2 radians, or (3/2) radians, an operation error will
be generated in the calculation of the radian value, so care must be taken to avoid such
errors.
Basic model QCPU: The upper five digits of the serial No. are "04122" or larger.
: Angle data of which the TAN (tangent) value is obtained or head number of the devices where the angle data
is stored (real number)
: Head number of the devices where the operation result will be stored (real number)
Setting
Data
Internal Devices
R, ZR
J\
U\G
Zn
Constants
E
Other
Bit Word Bit Word
–– ––
*2
––
–– ––
*2
–– ––
Process
High
performance
Redundant
Universal
Ver.
Basic
Command
Command
TANP
TAN
TANP
TAN S D
S D
S
D
S
D
S
D
+1
+1
S
D
S
D
32-bit floating-point
real number
TAN (
)
32-bit floating-point
real number
S
S