Filter
Top Products
141
CHAPTER 4 MENUS
-Fill
Figure 4.4-6 Memory operation Dialog (Fill)
To fill memory with data, open the [Fill] tag, then set the start address, end address, data type, and filling
data.
-Start Address
Specifies start address of memory area to be filled with data. Data filling is started at this address.
-End Address
Specifies end address of memory area to be filled with data. Data filling is continued to this address.
-Type
Specifies type of filled data. (Byte/Word/Long/Ascii)
-Fill Data
Specifies filling data to fill specified memory area. Several filling data can be specified, delimited by a
comma (,).