Filter
Top Products
275
CHAPTER 4 MENUS
4.7.2.4 Setup Wizard
This section explains how to operate the debugger's Setup Wizard.
■ Setup Wizard operation procedure
1. Select [Setup Name] from [Debugger Startup Selection], then click the [OK] button.
The check dialog box opens.
2. Click the [OK] button.
Debugger’s Setup Wizard is started.
3. Click the [Next] button.
4. Select a debugger type, then click the [Next] button.
Setting of the subsequent items depends on the debugger’s type.
To reset an item, click the [Return] button.
The immediately preceding setup screen is redisplayed.
■ Procedure when the emulator (MB2141) is selected
1. Select the ICE type.
2. Click the [Next] button.
3. Select [RS232C] or [LAN] as the device type.
When [RS232C] is selected, set a port and baud rate.
When [LAN] is selected, set a host name.
4. Click the [Next] button.
5. Set whether or not to automatically load the monitor program at debugging start.
6. Click the [Next] button.
7. Set whether or not to load the target file automatically during debugging.
8. Specify the batch files used before and after load as required.
Clicking the [Refer] button to the right of each input field enables batch file selection.
9. Click the [Next] button.
10. Select the item to be set in the setup file.
When [Specify] is selected, click the [Setup] button to open the item selection dialog box, select the
item to be set from the dialog box, then click the [OK] button.
11. Click the [Next] button.
12. Click the [Complete] button.
Emulator (MB2141) setup has been just completed.