Filter
Top Products
209
CHAPTER 4 MENUS
■ When initializing [Placement/link] option based on MCU information
1. Click the [Reset placement/link option] button.
- The placement/link option is reset.
When this reset is performed, the placement/link option is set as follows:
- Automatic placement (-AL 2)
Mode 2 (optimum automatic placement by linker) is set.
- ROM/RAM area (-ro, -ra)
The ROM/RAM area is all cleared and the currently selected MCU internal ROM/RAM address is set.
- Section information (-sc)
Section information is all cleared.
- A warning is output when a ROM/RAM area outside the range of the internal ROM/RAM (-check_rora)
is specified.
Setting is performed so as to output a warning. However, when an MCU without single-chip mode is
selected, setting is performed so as not to output a warning.
- A warning is output when a section is placed outside the specified ROM/RAM area range
(-check_locate)
Setting is performed so as to output a warning.